DOWSIL SE1714
Harmonization Code : 3919.10.80 | Other self-adhesive plastic rolls not exceeding 20 cm wide.
Main features
- One-Part No-Mix Bonding
- 30-Minute 150 deg C Cure
- 1,030 psi Cured Tensile Strength
Product Description
DOWSIL™ SE 1714 Adhesive is a one-part, black or beige, flowable addition-cure silicone adhesive and sealant for electronics and automotive assemblies. The ready-to-use material requires no mixing and is heat cured above 100°C, with a typical cure condition of 30 minutes at 150°C. Documented applications include sealing lids and housings for electronic control units and power modules, fixing printed circuit-board and system assemblies, and reinforcing connector components. Typical cured properties include Shore A 65 hardness, 1,030 psi tensile strength, 250% elongation, and a specific gravity of 1.3 at 25°C.
Key features
- One-part flowable adhesive: The ready-to-use material can flow, fill, or self-level after dispensing.
- Heat-cure processing: A typical cure condition is 30 minutes at 150°C.
- Strong cured elastomer: Typical data include 1,030 psi tensile strength and 250% elongation.
Applications / Suitable for
- Sealing lids and housings for ECUs and power modules
- Fixing PCB and system assemblies
- Reinforcing or fixing connector components
TDS, SDS & Technical Documents
Technical Specifications
No specifications available.
Additional Information
As-supplied / before-processing properties
Typical as-supplied or processing-state values unless otherwise stated. These values are not sales specifications.
| Property | Value | Unit | Method / condition |
|---|---|---|---|
| Product form | One-part flowable adhesive / sealant | N/A | As supplied |
| Color | Black or beige | N/A | As supplied |
| Cure type | Addition cure | N/A | Heat cure above 100°C |
| Typical cure | 30 | min | At 150°C |
After-processing / final-state properties
Typical cured, installed, or in-use values under the stated conditions. These values are not sales specifications.
| Property | Value | Unit | Method / condition |
|---|---|---|---|
| Specific gravity | 1.3 | N/A | At 25°C |
| Hardness | 65 | Shore A | Typical cured value |
| Tensile strength | 1,030 | psi | Typical cured value |
| Elongation | 250 | % | Typical cured value |
